setting_digital_clocks
Table of Contents
This is an old revision of the document!
Setting Digital Clocks
I have several digital clocks, here is how to set or change the time and parameters of each.
LED Digital Clock, DS-6628
Currently in smi livingroom
Features
- Two display modes: (1) Display time only, (2) Display time, date, and temperature in a cycle
- Five brightness settings
- Two alarms
- Voice controlled wakeup
- USB power with 3 AAA battery backup
General Settings
Start when showing time.
tap S | set 12h/24h mode | +/- |
tap S | set the hour | +/- |
tap S | set the minute | +/- |
tap S | set the year | +/- |
tap S | set the month | +/- |
tap S | set the day | +/- |
tap S | switch night mode | +/- |
tap S | exit setting mode |
Display mode setting: long press + to switch display mode (1) time only, (2) time, date, temp
Temperature unit setting: long press - for F or C
Brightness adjustment: short press SNOOZE, cycling through brightness 1-5.
Sharp
Setting the time
Press and hold TIME button and then while keeping it pressed:
- Tap HOUR button to advance the hour. PM indicator will light when in PM times.
- Tap MIN button to advance the minute.
- Release TIME button when correct time is showing
Setting the Alarm
- Follow procedure for setting time, while holding ALARM button.
- To use alarm, slide ALARM ON/OFF button to ON or OFF. Alarm indicator dot is visible when alarm is ON.
- When alarm sounds, press SNOOZE to stop alarm for 9 minutes.
Battery Backup
Uses 2 AAA batteries. When power is out, ALARM and TIME settings are retained; display is off; and alarm will sound if set.
setting_digital_clocks.1680962671.txt.gz · Last modified: 2023.04.08 07:04 by Steve Isenberg